FlexRay/CAN FD Interface for USB VN7610
VN7610 is ideally suited for the development, simulation or testing of FlexRay networks. The connection possibilities via USB make it universally applicable (for example in the laboratory or during a test drive). Due to its very compact design the VN7610 is especially suitable for mobile applications. In addition to FlexRay bus connection, the interface provides access also to CAN FD bus systems.
Advantage of VN7610
- Simulation of extensive networks due to 2 MB send memory (parallel configuration of more than 1000 messages for transmission)
- Cold start of the FlexRay cluster without needing to add a network node
- Analysis of the network startup via an independent monitoring unit
- 1 FlexRay channel (A and B)
- Ideal for CANoe/CANape/CANalyzer applications with CAN, CAN FD as well as FlexRay bus access
- Updating of functional range by FPGA update possible
- Minimal space requirements due to its compact and small design
Application Area of VN7610
- Flexible analysis of FlexRay networks and ECUs
- Precise time analysis of communication data
- Analysis and test of ECUs and gateway applications
- Customer-specific applications can be created by using FlexRay-specific libraries
Functions of VN7610
FlexRay
Dynamic reconfiguration of the CC buffers
Transmission and reception of data and null frames
Detection of invalid frames
Cycle multiplexing
In-cycle response
Hardware-based incrementing of a payload area
Support of PDUs
FlexRay gateway (channel A)
Startup + asynchronous monitoring allows detection of FlexRay frames and symbols, even before the communication controller has synchronized itself to the bus
General
Synchronization with several devices and other bus systems (e.g. CAN/ CAN FD)
Support of CAN FD up to 8 MBit
Fast CAN flashing through hardware-based flash sequence support
CAPL-on-Board for CAN and FlexRay