HARDWARE PRODUCTS

Special automotive data recorders which can be used in test vehicles or on test benches. They record measurement values and acquire the data communications of CAN/CAN FD, LIN, FlexRay and Ethernet bus systems.
Beside bus communication, customers can acquire internal ECU parameters via CCP/XCP and diagnostics as well as measured values of digital and analog inputs in a time-synchronous manner.

Software tools used to develop, simulate, test and maintain distributed systems require powerful and flexible network interfaces.

Vector offers you interfaces for CAN / CAN FD, LIN, J1708, Automotive Ethernet, FlexRay, 802.11p and MOST as well as driver software and programming interfaces for use with Vector software tools and in customer-specific solutions.

As your partner with many years of experience in the development of Automotive Ethernet solutions, Vector now offers a new and optimized way of accessing and using Ethernet network interfaces. This also includes new versions of the Ethernet interface software (device driver) for current and future interfaces.

FlexRay is a scalable, flexible high-speed communication system that meets the challenges of growing safety-relevant requirements in the automobile.

The VH1160 is a compact USB-based test hardware that automates ECU conformance tests for CAN and LIN. It is typically used by CANoe-based test implementations to automatically reset the ECU on the hardware side before each test case. Current measurement is used to determine the ECU states (sleep/wake-up). The ability to create short circuits on the network line allows you to perform simple tests on the robustness of an ECU.

VH6501 is a flexible yet compact CAN / CAN FD disturbance hardware and a network interface for CANoe combined in one device.

In particular, the combination of disturbance hardware and network interface allows very simple test setups for CAN / CAN FD conformance tests without an additional network interface or a special cable.

Tests of embedded systems often require complex and expensive test solutions, which is why they are only used in the later phases of the development process. With the VIO System, I/O testing can be performed much earlier.
Its compact design makes it ideal for use on the laboratory bench, enabling continuous testing and simulation at evaluation board level even in the earliest stages of development. Whether sensors, actuators or complete ECUs need to be tested during the HW/SW development phase, the VIO System covers all possibilities.